Automatic Handpiece Cleaning and Lubrication System

NSK Care3 automatically and correctly cleans and lubricates all high and low speed handpieces, plus air motors.
All day, every day-correctly every time.

The new NSK Care3 automatic handpiece cleaning and lubrication system has been developed by NSK to professionally clean and lubricate all handpieces and airmotors each time before autoclaving.
Every Care3 automati cycle cleans and lubricates 1,2 or 3 high speed and/or low speed handpieces, plus air motors. Handpieces are simply attached to any of the three Care ports.
At the touch of a button (S-Short: high speed cycle or L-Long: low speed cycle) each handpiece is automatically programmed for correct maintenance and lubrication. 40 seconds after the Start button is pressed all handpieces and air motors are correctly cleaned and lubricated, ready for autoclaving.
NSK Care3 automatically purges excess lubrication solution from each handpiece. Further, Care3 automatically extracts any solution vapour from the sealed cleaning chamber via a fine filter. When the chamber cover is opened to no solution vapour is emitted. A solution indicator visually shows the level of solution remaining in the integrated tank, and automatically warns if the solution requires replenishing. When coupled to a high pressure air connection, Care3 automatically adjusts down to the correct air pressure required for each operating cycle. Care3 automatically warns if a cycle has not been successfully concluded.